Series 291

CRU

This product has been discontinued. Please contact your local sales representative for further assistance.

Generic Type

Aliphatic Polyester Polyurethane

Common Usage

Extremely hard, chemical-resistant polyurethane floor coating with superb flow characteristics. Excellent resistance to abrasion, wet conditions, corrosive fumes and chemical contact. Gloss and color retention among the best of air dried finishes. Note: For horizontal surfaces only.

Volatile Organic Compounds

Unthinned: 2.91 lbs/gallon (348 grams/litre)
Thinned 15%: 3.34 lbs/gallon (401 grams/litre) †

Finish

Gloss

Theoretical Coverage

994 mil sq ft/gal (24.4 m²/L at 25 microns). See APPLICATION for coverage rates. †

Colors

Available in the 16 standard StrataShield colors and limited custom colors. Contact Tnemec Company for availability. Note: Certain colors may require multiple coats depending on method of application and finish coat color. When feasible, the preceding coat should be in the same color family (blue, gray, etc.), but noticeably different.

Volume Solids

62% ± 2.0% (mixed) †

Primers

Horizontal Concrete: Series 201, 203, 205, 280, 281, 287.

Recommended DFT

2.0 to 3.0 mils (50 to 75 microns) per coat. Note: Number of coats will vary depending on color, substrate (surface) and other variables. Contact your Tnemec representative.

Curing Time

Temperature Min. Recoat To Service Chemical Resistance
75°F (24°C) 12 hours 24 hours 7 days

Curing time varies with surface temperature, air movement, humidity and film thickness.

Intermediate

Series 104, 205, 210, 237, 238, 239, 280, 281, 287
Note: Before topcoating with Series 291, any Tnemec epoxy exterior exposed for more than three weeks must be scarified or reprimed with itself. Mechanically abrading or power-sanding is the preferred method of scarification. The maximum recoat time of Series 210, 237, 238, 239, 280 and 281 is 24 hours. Refer to those product data sheets for more information. Note: Scarification using a power sander and 100 grit sandpaper, No. 60 mesh sanding screen or a coarse stripping pad is required if topcoating Series 291 with itself. Note: When applying Series 291 over a broadcast or mortar system, an epoxy grout coat is required.

Number of Components

Two: Part A and Part B (2.5 Parts A to 1 Part B by volume)

Continue Exploring in the color tool

Close

Color Swatch packet

You can use our Color Tool page to explore our available colors and request swatches of colors you like.

Sorry, there is a maximum of 6 color swatches.

Request swatch packet

Continue Exploring in the color tool

Close